HEALTH AND SAFETY REQUIREMENTS
HEALTH AND SAFETY REQUIREMENTS.
Customer shall comply, at all times, with all the legislation that is applicable with respect to the application, handling, storage, manufacture and disposal of the products sold by ARTEACO, S.L.. Specifically, the customer must carry out, with respect to each of their jobs, periodic risk assessments in accordance with applicable industry regulations and implementing appropriate risk control measures. The customer acknowledges that the manufacture / processing of products, especially by dry cutting, emits dust, including respirable crystalline silica, which can cause silicosis or other respiratory diseases. ARTEACO, S.L. recommends manufacturers / marmolistas that all necessary preventive measures are taken including performing the following tasks wet machining: cut, calibrated, polishing and retouching. Products ARTEACO, S.L They are totally safe if they are prepared and treated according to the guide of good practices and the safety data sheet that are available in www.arteaco.es. Do not hesitate to order them. Not limited to the main preventive measures are (i) eliminate or minimize the generation of dust always using machinery equipped with delivery systems abundant water (ii) prevent or minimize the passage of dust to the environment using extraction systems located at points of dust generation (iii) not sweep, clean equipment and work areas with wet cleaning media or means of industrial extraction (iv) regularly monitoring exposure to respirable particles of crystalline silica (v) use personal protective equipment against dust type P3 or FFP3 (we) establish a specific system health monitoring If the customer resells the products shall be obliged to provide all information on safety and health in the same terms as described above.